Suspension Forks and Shocks

- Protective neoprene and velcro cut-To-Fit boot fits most rear shocks

- Two machined aluminum spacers (some kits may include a sleeve) for mounting one end of Manitou rear shocks (air or coil) - Sold as a set of two spacers: two sets required per shock, one per each eyelet - Sized by bolt diameter: M6, M8, or M9.5 (3/8-inch) and frame mount ID width (in mm) - This hardware is for <2010 shocks with 12.5mm eyelets

Service kits include dust seals, foam rings, oil seals, air and damper o-rings needed for basic service.

- Clamps on to dual-Crown fork stanchions to prevent damage to frame - Easy to install and adjust, More secure and lower profile than stock bumpers - Molded loops allow clean and easy zip-Tie number plate mounting - Available for 35mm boxxer or 40mm fox stanchions, Sold in pairs

Optional mud guard designed specifically for the new 36, 38. Proprietary and sturdy 4-point direct-mount attachment. Note: The FOX 36 and 38 Mud Guards have the same mounting points and are interchangeable between models. The FOX 36 and 38 Mud Guards fit on all 2021 and newer Performance, Performance Elite and Factory models. The FOX 40 Mud Guard only fits the 2021 and new FOX 40 models. Supplies Needed for the install 13mm Socket 2.5mm Hex Wrench 5mm Hex Wrench Ratchet Seal Pick Torque Wrench

- Two machined aluminum spacers (some kits may include a sleeve) for mounting one end of Manitou rear shocks (air or coil) - Sold as a set of two spacers: two sets required per shock, one per each eyelet - Sized by bolt diameter: M6, M8, or M10) and frame mount ID width (in mm) - This hardware is for 2011+ shocks with 15mm eyelets

- Replacement leg guards for Dorado forks

Designed for RockShox Vivid and Kage rear/frame shocks

Service your suspension fork with Enduro Seal KIts. - Custom made for each make and model of fork

Fox Shox TLG Spring Constructed from proprietary Fox standard steel 1.38" inside diameter fits Fox VAN/DHX/DHX2 Sizing is defined as (Spring Rate X Shock Stroke) *example 550 X 2.35

Multi-step surface treatment process and special heat treatment for the lightest, strongest spring. *Some coil/springs have been installed previously.

Multi-step surface treatment process and special heat treatment for the lightest, strongest spring *Some coil/springs have be installed previously.

Multi-step surface treatment process and special heat treatment for the lightest, strongest spring *Some coil/springs have been installed previously.

Multi-step surface treatment process and special heat treatment for the lightest, strongest spring *some coil/springs have been installed previously

Multi-step surface treatment process and special heat treatment for the lightest, strongest spring *some coil/springs have been installed previously

Ohlins rear shock coil/spring with 75mm stroke *Some are lightly used or have been installed previously.

Constructed from proprietary Fox super light steel (SLS) 1.38" inside diameter fits Fox VAN/DHX/DHX2 Sizing is defined as (Spring Rate X Shock Stroke) *example 550 X 2.35

The LS (Light Steel) Spring is made of high grade Japanese steel and saves close to a pound over a traditional steel spring Retains its weight rating and integrity longer than any other light steel spring on the market

• High-tensile steel construction • Threadless

- Replacement damper kits

• High-tensile steel construction • Springer suspension • Threaded • 1-inch diameter (7/8-inch inner diameter) • 20-inch version steerer length: 148mm • 26-inch version steerer length: 180mm

Progressive springs for the MRP Hazzard rear shock - spring rate changes from beginning to end of stroke Correct spring spacer may be needed for certain applications

Up to 125lbs of progressive rate coil. Great for that big hit support for aggressive riders or linear linkage designs Lightweight and high quality Japanese steel Retains spring-rate up to 1,000,000 compressions Longest spring life of any lightweight steel spring on the market Available for a 50, 52.5, 55, 57.5, 60, 62.5, and 65mm stroke Jade/Jade X shocks. If you have a 50-55mm stroke shock, get the 55mm spring. If you have a 57.5-65mm shock, get the 65mm stroke spring. If your shock does not have any of the above stroke lengths, the ProRate Spring will NOT work

A day of slicing through sweet ribbons of singletrack on a bike sporting a RockShox 30 Silver will leave you smiling all the way to the bank. Race-proven plushness and ease of setup means more time on the trail and less time tinkering. Lightweight and packed full of legendary RockShox technology, the 30 Silver is sure to boost the level of your ride without boosting your wallet in the process. - TurnKey damper - Crown Race: 30mm - Steerer Tube Length: 265mm - Positive Spring: Coil - Negative Spring: Coil - External Adjustments: Rebound Damping, Low Speed Compression Damping - Maximum Tire Width: 62mm - Maximum tire size: 26 x 2.4"

RockShox Boxxer Solo Air Assembly

Premium performance at down-to-earth prices. Judy now includes all of the 30mm MTB and E-MTB forks, with axle and steerer options to match any spec. Silver level forks give you stiff steel upper tubes and TurnKey lockout. Features - New graphics package with E-MTB endorsement option (15x110mm) - TurnKey lockout gives 'on/off' control - Fits Tires up to 2.8" (15x110mm) - Fast Black finished 30mm steel upper tubes couple stiffness and lightweight with a premium look - Plush, highly tunable Solo Air spring - Disc brake compatible - Offset: 51mm (29-inches) - Steerer Diameter: 1.5-inch Tapered

Handles terrain like a goat. Just because you're on a budget doesn't mean you can't ride a suspension fork that gives you excellent, smooth control. The Markhor features our KwikToggle damper with easy on/off lockout. With travel between 100mm and adjustable to 120mm, 80-100mm on (26"), the Markhor fork smooths out any line the trail puts in front of you. - Cost-effective and lightweight air spring fork that features the same Twin-Piston Chamber (TPC) rebound damping as the more expensive Manitou forks - 30mm aluminum stanchions with aluminum steerer - 100mm or 120mm Travel - 80-100mm on (26") - TS Air Spring - Kwik Toggle Compression Damping - TPC Rebound Damping

An entry level fork with the latest features and performance; Judy Silver is built around a brand new chassis derived from the Pike, works with Plus tires up to 2.8 in both the 27.5" and 29" models. Judy Silver features the Motion Control RL damper and is compatible with OneLoc remotes and has Fast Black upper tubes for an all-black look and low friction performance. - 80-120mm travel - External rebound - TurnKey lockout controls - Fast Black upper tubes - Motion Control RL damper - Compatible with OneLoc remote

With optimized material concentrated at the brace and seal area, outstanding stiffness and steering precision, and new E-MTB configured fork options with fender mounting points, Recon Silver is an all-around performer suited for any MTB or E-MTB bike. Features - New E-MTB endorsement options with fender mounts are appropriate for all E-bikes (15x110mm version) - New graphics are easy to read and make a fresh impact - Motion Control damping featuring low-speed compression adjustment to lockout - Fit Tires up to 2.8" (15x110mm version without fenders; the use of a full fender will reduce tire clearance) - Fast Black finished 32mm steel upper tubes couple stiffness with a premium look

The RockShox Recon Silver: a fork with the performance that'll help you beat your riding buddies without beating up your checking account. Sturdy 32-millimeter stanchions, stiff, forged aluminum crown, and dependable Solo Air spring make Recon Silver the fork you've been looking for. Solo Air lets you add air to your forks through a single Schrader valve, filling both the positive and negative air spring chambers simultaneously, and the Turn Key oil damping system offers external rebound adjustment and compression lockout for on-the-trail adjustability. - PopLoc compatible - 2.4" (62mm) maximum tire width - Crown Race: 30mm - Offset: 40mm - Steerer Tube Length: 265mm - Positive Spring: Air - Negative Spring: Air - Travel: 100mm - Wheel Size: 26" - Stanchion Diameter: 32mm